🌞 Winter Specials! | 🌡️ AC, Heater & Split System Cleaning | 💧 Evap Cooler Service | 🔍 HVAC Inspections | 📞 Call Today for a Free Quote!
🌞 Winter Specials! | 🌡️ AC, Heater & Split | 💧 Evap Cooler | 🔍 HVAC Check | 📞Free Quote!
Reservoir is one of Melbourne's largest suburbs by area, a broad northern expanse of post-war brick and weatherboard homes filled in through the 1950s and 60s, with older interwar bungalows closer to the Preston border. FreshDuct installs certified R6.0 ceiling insulation across Reservoir.
Three details and we'll call you back — usually the same day.
Reservoir is one of Melbourne's largest suburbs by area, a broad northern expanse of post-war brick and weatherboard homes filled in through the 1950s and 60s, with older interwar bungalows closer to the Preston border. The housing is solid and roomy but overwhelmingly from an era when insulation was an afterthought — many of these ceilings have never held more than a thin token layer.
The good news is that Reservoir's post-war roofs are simple and accessible, so upgrading them is fast and tidy. Time and again we find bare ceilings or settled batts that have compacted well below their rated value, leaving homes that overheat under the summer sun and lose warmth on cold nights. A clean, continuous R6.0 blanket across the whole ceiling transforms comfort in these homes and takes the load off older heating and cooling.
A lot of Reservoir's post-war homes have little to no ceiling insulation. A full R6.0 layer is the single biggest comfort improvement available to them.
These homes have big, accessible roofs — quick to insulate, but with long eave runs that need hand-fitting so the perimeter isn't left bare.
Older bungalows toward Preston often carry compacted original insulation. We measure the real depth and top up or replace to restore a full R6.0.
Heat rises, and in an under-insulated home it pours out through the ceiling in winter and floods in from a baking roof cavity in summer. The ceiling is the single biggest thermal weak point in most Melbourne homes — which is why it's the first place to fix and the one that returns the most comfort for the money.
A properly insulated ceiling isn't just a layer of batts thrown in. It's a continuous, sealed R6.0 blanket that reaches the eaves, wraps around every penetration and leaves no cold gaps — so your heating and cooling stop fighting a constant loss and the whole house holds a steadier temperature.
Recent insulation work across Melbourne — the same certified R6.0 standard we bring to every Reservoir job.
| Ceiling insulation standard | Cheap installers | FreshDuct |
|---|---|---|
| Roof inspection | Quoted blind or over the phone | We get into the roof, measure the existing R-value and check access first |
| Coverage | Batts dropped in the middle, eaves left bare | Hand-fitted right to the eaves and sealed around every gap |
| R-value | Whatever is cheapest | A full R6.0 ceiling standard with certified thermal batts |
| Old insulation | Left in place or covered over | Removed and the cavity vacuumed clean where it is damaged or contaminated |
| Clearances | Ignored around downlights & flues | Correct clearances kept around downlights, flues and wiring |
| Proof of work | None | Before & after photos of your finished roof |
A continuous, sealed R6.0 layer across your whole ceiling — no cold gaps left behind.
We get into the roof space, measure the existing insulation and R-value, and check access, wiring and any moisture.
You get a fixed written quote — including removal of old or damaged insulation if the cavity needs clearing first.
Certified installers hand-fit certified batts end to end — right to the eaves, sealed around every gap — for an even, continuous layer.
We confirm full coverage and correct clearances, then hand over before/after photos of the finished roof.
A properly insulated ceiling cuts the heat lost in winter and gained in summer, so your heating and cooling run less.
Rooms stop swinging hot and cold — the whole home holds a steadier, more comfortable temperature.
We install to a full R6.0 ceiling standard with certified thermal batts, not whatever happens to be cheapest.
Certified R6.0 batts, old-insulation removal and top-ups in the roof space.
The full FreshDuct home insulation range across Melbourne.
Batts between the floor joists to stop cold floors and downward heat loss.
Retrofit cavity fill and new-wall insulation for a continuous thermal barrier.
Full roof, wall and floor insulation for new builds to NCC / BASIX.
Industrial vacuum removal of old, damaged or contaminated insulation.
We serve Reservoir and the northern suburbs — Preston, Thornbury, Coburg, Bundoora and across to Thomastown. Free inspections at no obligation.
We insulate homes right across Reservoir and the surrounding suburbs.
It depends on the ceiling area, which in these larger homes can be sizeable — that's exactly why we measure and give a fixed written quote rather than a phone estimate. The roofs are accessible, though, so the work itself is usually quick and clean.
Only if it's damaged, damp or contaminated. If it's clean and dry we top up over it to reach a full R6.0. If it's degraded, we vacuum it out and leave the cavity clean before installing fresh batts. We confirm which on inspection.
It depends on your ceiling area, the R-value and whether old insulation needs removing first. That's why we inspect the roof and give a fixed written quote rather than a phone estimate — no call-out fee and no obligation.
If the existing insulation is damaged, damp or contaminated, yes — we vacuum it out with industrial equipment and leave the cavity clean and inspectable before installing new R6.0 batts. If it's clean and dry, we can top up over it.
Most single-storey homes are done in a day. Larger or two-storey homes, or jobs that need old insulation removed first, can take a little longer — we confirm the timeframe with your quote.
Book a free roof inspection and fixed written quote for your Reservoir home — no call-out fee, no obligation.
No call-out fee, no obligation.
