🌞 Winter Specials! | 🌡️ AC, Heater & Split System Cleaning | 💧 Evap Cooler Service | 🔍 HVAC Inspections | 📞 Call Today for a Free Quote!

🌞 Winter Specials! | 🌡️ AC, Heater & Split | 💧 Evap Cooler | 🔍 HVAC Check | 📞Free Quote!

FreshDuct Air Duct Cleaning Logo
Local bayside south-east Team Before & After PhotosNo Call-Out Fee

Chimney Repairs in Frankston

Salt off the bay and a hard-working heater are a tough pairing for a Frankston chimney. FreshDuct repairs rusted flashing, cracked crowns and heat-damaged mortar on post-war brick stacks, relines flues that have had a heater fitted, and photographs it all.

Rust streaks running down the brick or the iron below the chimney? The flashing has gone, and it is a repair, not a repaint.

Where a wood heater was set into an old open fireplace without a liner, the unlined brick above it has been taking heater temperatures for years. Cracked mortar inside the flue is the usual result, and a camera finds it long before a fire would.
Coastal Chimney Repairs

Repairing salt-worn and heat-worn chimneys in Frankston

Many Frankston chimneys are post-war brick, built to serve an open fire and later asked to carry a wood heater instead. That change matters. A heater pushes hotter gases through a flue built for a lazy open fire, and where no liner was fitted the mortar joints inside the brick dry out, crack and drop, until the camera shows gaps between the bricks. On the outside, the bay is doing its own work on the stack.

That outside work is mostly salt. Galvanised flashing on the iron and tile roofs near the water rusts through at the folds and leaves a tell-tale orange streak down the brick or the roof sheet below; cement crowns crack and let rain into the top of the stack; and mortar on the face that takes the sea wind erodes back from the brick. Each of these shows up inside as damp, rust stains or a smell of wet soot after weather.

We inspect the lot before quoting: the stack and crown from the roof, the flashing at the fold, and the inside of the flue on camera. Repairs are matched to the fault. Rusted flashing is replaced with a corrosion-resistant material and dressed properly to the roof; crowns are rebuilt to shed water; eroded joints are repointed; and a flue that has been cooked by a heater gets a stainless liner sized to that appliance.

What's Included

Chimney Repairs in Frankston — what we do

Flashing, crown, repointing and stainless relining for Frankston's post-war chimneys, whether the damage is from the bay or the heater.

Photographed inspection of the stack, crown, flashing, mortar and flue
Repointing and tuckpointing of weathered mortar joints
Cracked or spalling brick cut out and replaced to match
Crown and cap repairs that stop water getting into the stack
Flashing resealed or replaced where the chimney meets the roof
Flue repairs and stainless steel relining where the liner has failed
Local Know-How

Chimney Repairs in Frankston: what is different here

Rusted-through flashing

Galvanised flashing near the bay goes at the folds and fixings first. We replace it with a corrosion-resistant material and dress it to the iron or tile properly, so the streak down the brick does not come back.

Heater in an unlined flue

A wood heater set into an old open fireplace runs the brick above it hotter than it was built for. If the camera shows cracked or missing mortar in the flue, a stainless liner sized to the heater is the fix, and we quote it firm.

Cracked crowns and open joints

Rain gets into a Frankston stack through a cracked crown or the eroded joints on the sea-facing side, then shows inside as damp. We rebuild the crown with a fall and repoint the weathered face rather than rendering over it.

Real Jobs

FreshDuct chimney work, photographed

Real photos from Melbourne jobs — not stock, not staged.

Cutting out and replacing damaged bricks on a Melbourne chimney.
Cutting out and replacing damaged bricks on a Melbourne chimney.
Repointing and tuckpointing tired mortar joints on a Melbourne brick chimney.
Repointing and tuckpointing tired mortar joints on a Melbourne brick chimney.
A repaired crown and cap on a Melbourne chimney stack.
A repaired crown and cap on a Melbourne chimney stack.
A FreshDuct technician repairing a chimney on a Melbourne roof
Bay or Heater

Finding which one wrecked the chimney

A Frankston chimney can be failing from the outside in, from salt and rain, or from the inside out, from a heater running too hot for the flue. The inspection sorts out which, with photos of each fault.

The quote covers only what has failed. If the flue is sound and it is just the flashing, that is what we fix, and you get photos of the finished repair from the roof.

Book Chimney repairs in Frankston

How We Work

The FreshDuct chimney repairs process

Documented end to end — every job, every suburb.

1

Inspect

Camera and photo inspection of the stack, crown, flashing and flue.

2

Diagnose

We find the real cause — water, movement or heat — and explain it.

3

Quote

A firm price for only what is needed, before any work.

4

Repair

Masonry, crown, flashing or flue work done properly and safely.

5

Check

Draw and weather-tightness confirmed.

6

Photos

Before and after photos and honest advice on what to watch.

5-Star Rated

What Melbourne Customers Say

Verified 5-star reviews from across FreshDuct’s duct, heating, cooling and chimney services.

★★★★★

“Allen provided exceptional service — friendly, professional and went above and beyond.”

J

Jane
Wantirna South, VIC

Verified

★★★★★

“Highly impressed with the professionalism and efficiency. On time, and no mess left behind.”

R

Ralph
Brighton, VIC

Verified

★★★★★

“Exceeded my expectations. Knowledgeable, meticulous and respectful of our home.”

M

Marc
Cranbourne East, VIC

Verified

★★★★★

“So glad I chose FreshDuct. Knowledgeable team and the whole process was smooth from start to finish.”

D

David
Williams Landing, VIC

Verified

★★★★★

“Quick, efficient and professional — we could immediately feel the difference.”

J

Juliette
Croydon, VIC

Verified

★★★★★

“The technician arrived on time and was incredibly thorough — the difference at home is obvious.”

S

Verified Customer
South Morang, VIC

Verified

FAQs

Chimney Repairs in Frankston — questions answered

There is an orange streak down the brick below my Frankston chimney — what is it?

Rust washing off failed galvanised flashing, which salt air near the bay corrodes at the folds and fixings. Water is likely getting in behind it. We inspect from the roof, replace the flashing with a corrosion-resistant material and dress it properly to the roof.

We put a wood heater into the old fireplace in our Frankston house years ago — should the chimney be checked?

Yes, on camera. A heater in an unlined brick flue runs it hotter than an open fire did, and the mortar inside often cracks and drops out. If the camera shows that, a stainless liner sized to the heater is the repair, quoted firm after the inspection.

How do I know if my chimney needs repair?

White staining, crumbling mortar, loose or missing bricks, rust marks on the roof, water in the firebox after rain, or smoke seeping into rooms are the usual signs. A photographed inspection tells you what is cosmetic and what is not.

Do you reline flues?

Yes — stainless steel liners for cracked or unlined flues on open fireplaces and wood heaters, quoted firm after a camera inspection. Gas flue work goes through the licensed gas specialists we arrange.

Can you repair a chimney without scaffolding?

Often, with roof access and harness work. Taller or unstable stacks need scaffold, and we tell you before quoting rather than after.

Book Chimney Repairs

Chimney Repairs in Frankston — free quote, firm price, pay after

Send your details and the office confirms a window for Frankston. No call-out fee, before and after photos, and honest advice on what your chimney needs and what it does not.