🌞 Winter Specials! | 🌡️ AC, Heater & Split System Cleaning | 💧 Evap Cooler Service | 🔍 HVAC Inspections | 📞 Call Today for a Free Quote!

🌞 Winter Specials! | 🌡️ AC, Heater & Split | 💧 Evap Cooler | 🔍 HVAC Check | 📞Free Quote!

FreshDuct Air Duct Cleaning Logo
Local outer west growth Team Before & After PhotosNo Call-Out Fee

Chimney Repairs in Tarneit

Tarneit flues are too new to have worn out, so what fails is what was never quite right: a flashing boot not seated on the Colorbond, a terminal loosened by wind off open ground, a section not locked. FreshDuct finds it on camera and fixes it.

Drip beside the flue in a house this new? Look to the roof, not the heater — and get it photographed.

New does not mean sealed. A flue fitted in a hurry on a building site can leak from its first storm, and on Tarneit's exposed streets the wind finds every loose fixing.
New-Build Flue Repairs

Flue repairs on Tarneit's new estates, most of them at the roof

There is almost no masonry to repair in Tarneit, so chimney repair here means flue repair, and nearly all of it happens where the pipe goes through the roof. The homes are new, the flues are new, and the faults are installation faults rather than age: a flashing boot never properly bedded to the Colorbond profile, sealant applied on a dusty day, a top section pushed on but not locked, a terminal held by fixings that were adequate on a still afternoon.

Then the weather arrives. Tarneit sits on open growth-corridor ground with very little to slow the wind, and driven rain finds every gap in a flashing that was only ever nearly right. A double-storey roof takes the full force of it. The result is a drip beside the flue in the upstairs ceiling, a stain spreading around the ceiling plate, or a terminal that has shifted and lets water straight down the pipe.

We inspect the flue on camera and the roof penetration in person before quoting, because the fix for a badly seated boot is not the fix for a loose section. Flashing is rebedded or replaced to suit the roof profile, sections are relocked and terminals refixed with fasteners meant for an exposed roof. Gas fire flues get the same treatment on the flue side, with the licensed gas specialists we arrange for the appliance.

What's Included

Chimney Repairs in Tarneit — what we do

Flashing, joint and terminal repairs for the new steel flues in Tarneit's estates, diagnosed at the roof and quoted firm before any work.

Photographed inspection of the stack, crown, flashing, mortar and flue
Repointing and tuckpointing of weathered mortar joints
Cracked or spalling brick cut out and replaced to match
Crown and cap repairs that stop water getting into the stack
Flashing resealed or replaced where the chimney meets the roof
Flue repairs and stainless steel relining where the liner has failed
Local Know-How

Chimney Repairs in Tarneit: what is different here

Flashing that was never right

A flashing boot fitted to the wrong Colorbond profile or bedded on a dusty sheet leaks from the first heavy rain. We strip it back, fit the right boot for the roof and seal it properly, then photograph it so you can see the difference.

Terminals worked loose by wind

Wind across open ground works at a two-storey terminal until the fixings give. A loose terminal rocks, lets rain down the flue and eventually goes. We refix it with fasteners suited to an exposed roof and check the section below it.

Gas flues, kept in their lane

Where the flue serves a gas fire, we handle the flue and its roof penetration and nothing on the appliance side. Anything at the fire itself goes to the licensed gas specialists we arrange, so the right trade does the right part.

Real Jobs

FreshDuct chimney work, photographed

Real photos from Melbourne jobs — not stock, not staged.

Cutting out and replacing damaged bricks on a Melbourne chimney.
Cutting out and replacing damaged bricks on a Melbourne chimney.
Repointing and tuckpointing tired mortar joints on a Melbourne brick chimney.
Repointing and tuckpointing tired mortar joints on a Melbourne brick chimney.
A repaired crown and cap on a Melbourne chimney stack.
A repaired crown and cap on a Melbourne chimney stack.
A FreshDuct technician repairing a chimney on a Melbourne roof
Roof First

Where a new flue actually leaks

On a house this new the leak is at the roof, so that is where we start. The penetration, the flashing and the top sections are inspected and photographed before the camera goes up the flue from below.

You are quoted for the part that has failed, and the repair is photographed from the roof afterwards. A rebedded boot is a small job; we do not dress it up as a bigger one.

Book Chimney repairs in Tarneit

How We Work

The FreshDuct chimney repairs process

Documented end to end — every job, every suburb.

1

Inspect

Camera and photo inspection of the stack, crown, flashing and flue.

2

Diagnose

We find the real cause — water, movement or heat — and explain it.

3

Quote

A firm price for only what is needed, before any work.

4

Repair

Masonry, crown, flashing or flue work done properly and safely.

5

Check

Draw and weather-tightness confirmed.

6

Photos

Before and after photos and honest advice on what to watch.

5-Star Rated

What Melbourne Customers Say

Verified 5-star reviews from across FreshDuct’s duct, heating, cooling and chimney services.

★★★★★

“Allen provided exceptional service — friendly, professional and went above and beyond.”

J

Jane
Wantirna South, VIC

Verified

★★★★★

“Highly impressed with the professionalism and efficiency. On time, and no mess left behind.”

R

Ralph
Brighton, VIC

Verified

★★★★★

“Exceeded my expectations. Knowledgeable, meticulous and respectful of our home.”

M

Marc
Cranbourne East, VIC

Verified

★★★★★

“So glad I chose FreshDuct. Knowledgeable team and the whole process was smooth from start to finish.”

D

David
Williams Landing, VIC

Verified

★★★★★

“Quick, efficient and professional — we could immediately feel the difference.”

J

Juliette
Croydon, VIC

Verified

★★★★★

“The technician arrived on time and was incredibly thorough — the difference at home is obvious.”

S

Verified Customer
South Morang, VIC

Verified

FAQs

Chimney Repairs in Tarneit — questions answered

Our Tarneit home is nearly new and there is water dripping beside the flue upstairs. How can a new flue leak?

Because the flashing was never properly seated when the flue was installed, and driven rain across open ground has found the gap. It is common on new builds. We inspect from the roof, rebed or replace the boot to suit the roof profile and photograph the repair.

The terminal on our Tarneit flue rattles in the wind. Is that dangerous?

It is a fixing that is letting go, and on an exposed double-storey roof it will not stop on its own. A loose terminal lets rain down the flue and can eventually come off. We refix it with fasteners suited to the exposure and check the section beneath it.

How do I know if my chimney needs repair?

White staining, crumbling mortar, loose or missing bricks, rust marks on the roof, water in the firebox after rain, or smoke seeping into rooms are the usual signs. A photographed inspection tells you what is cosmetic and what is not.

Do you reline flues?

Yes — stainless steel liners for cracked or unlined flues on open fireplaces and wood heaters, quoted firm after a camera inspection. Gas flue work goes through the licensed gas specialists we arrange.

Can you repair a chimney without scaffolding?

Often, with roof access and harness work. Taller or unstable stacks need scaffold, and we tell you before quoting rather than after.

Book Chimney Repairs

Chimney Repairs in Tarneit — free quote, firm price, pay after

Send your details and the office confirms a window for Tarneit. No call-out fee, before and after photos, and honest advice on what your chimney needs and what it does not.