🌞 Winter Specials! | 🌡️ AC, Heater & Split System Cleaning | 💧 Evap Cooler Service | 🔍 HVAC Inspections | 📞 Call Today for a Free Quote!
🌞 Winter Specials! | 🌡️ AC, Heater & Split | 💧 Evap Cooler | 🔍 HVAC Check | 📞Free Quote!
Like-for-like replacements, brand-new installations in rooms that never had a fan, timer and humidity-sensor upgrades – sized to the room and ducted properly to the roof or eave, so the steam actually leaves your house instead of touring it.
Tick two or more and it is time to book — every one of these gets worse, never better, on its own.
Perth adds a factor most cities do not: salt. Coastal air corrodes the metal parts of an exhaust system – motor housings, fixings, and especially the backdraft damper at the discharge. A seized, corroded damper is one of the most common causes of both the flapping noise and the lost airflow we find in suburbs near the coast.
Perth’s long hot summers also mean bathrooms and laundries get used hard with the house shut up against the heat, while limestone and brick construction keeps interior surfaces cool enough to condense steam. Extraction that leaves the building is the fix; recirculating the same moist air around the house is not.
A fan screwed into the ceiling is not an installation – it is a decoration. A proper job sizes the fan to the room’s volume, wires it safely through a licensed electrician, and ducts the discharge all the way to the roof or eave so the moist air leaves the building.
The shortcut we will not take: venting into the roof cavity. It is the cheapest path and the most expensive mistake – it relocates your bathroom’s moisture into the one space you never inspect, where it condenses on timber and insulation and grows mould you cannot see. Every FreshDuct installation discharges outside. No exceptions.
Where wiring and ducting already exist, a like-for-like replacement is quick: from $250 as a complete supply-and-install job, typically $280 to $480 depending on the fan you choose. A brand-new location – new wiring, new duct run, new discharge point – generally runs $550 to $1,200 as a complete job, quoted firm before we start.
Size beats brand. Extraction capacity is measured in cubic metres per hour, and the fan must match the room: a powerful ensuite fan is wasted in a toilet, and a toilet fan in a family bathroom is why the mirror never clears. We calculate it from the room, not from what is on special.
Controls do the remembering. A run-on timer keeps extracting for the minutes after your shower when most of the moisture is still airborne. A humidity sensor switches the fan on before the mirror fogs and off when the room is dry – the set-and-forget answer for kids’ bathrooms and rentals. Both can be added to a fan you already own, and both remove the one variable no fan can control: whether anyone remembers to switch it on.
We install ceiling and wall models, inline fans for long duct runs, quiet low-sone units for bedrooms-adjacent bathrooms, and 3-in-1 heater-fan-light units – all major Australian-market brands.
Trusted by thousands of clients — homes, councils, universities & agencies
Brands we service — heating, cooling & fireplaces
The difference between a fan that is mounted and a fan that works is almost entirely in the parts you cannot see.
Bathroom, ensuite, laundry or toilet; existing fan or first-ever; single storey or double. That is enough for a firm quote in most cases.
Like-for-like from $250 complete. New locations quoted on wiring and duct run – firm before we start, never adjusted after.
Sized to the room, ducted to the roof or eave, and wired safely. Timers and humidity sensors fitted if you want them.
We test real extraction before we leave, you get the photos, and payment happens when you are happy.
Real reviews from verified FreshDuct customers — find hundreds more on our Google profile.
Rated 5 out of 5 stars
“Cannot say enough about Gabriel and his team. They were very professional with their job. He taught me what I am supposed to know about vents and how to take care of them. They did an amazing job.”
Rated 5 out of 5 stars
“Our ducts had not been cleaned in 9 years. I was really happy with their professionalism and speed. They respected our house rules and the air in my home is really fresh and clean.”
Rated 5 out of 5 stars
“Outstanding service! Manny was very professional and polite. This is by far the most thorough cleanup that we have experienced. All vents were cleaned and sanitised.”
Rated 5 out of 5 stars
“Adam and his team were professional and very service oriented. They provided detailed before and after pictures to confirm the work and effort. Highly recommend FreshDuct.”
Rated 5 out of 5 stars
“Tom and Eddie did an outstanding job cleaning my air ducts. I scheduled my appointment yesterday and the job was completed within 24 hours. Very satisfied with the service.”
Rated 5 out of 5 stars
“We had pet stains and a bad smell in the carpet and air ducts. After FreshDuct visited, the house smells fresh and clean again.”
Rated 5 out of 5 stars
“Our house flooded in the storms with over a metre of water. FreshDuct came recommended by our neighbours and arrived the same day.”
Rated 5 out of 5 stars
“They were clear up front about pricing and exactly what was included. Very thorough from start to finish.”
Branded vans, uniformed technicians, professional equipment — the team your neighbours already know.
Like-for-like replacement – where wiring and ducting already exist – starts from $250 as a complete supply-and-install job and is typically $280 to $480 depending on the fan. A new location, with new wiring and a duct run to the roof or eave, generally runs $550 to $1,200 complete. You get a firm number before any work starts.
Bathrooms need ventilation – natural or mechanical. No openable window means mechanical extraction is the compliant path in practice. If you are renovating, selling or leasing, this is one of the cheapest compliance items to get right.
Because a fan that dumps steam into the roof cavity has not removed the moisture – it has hidden it above your ceiling, where it condenses on cold timber and breeds mould out of sight. Every FreshDuct installation ducts to the roof or eave so the air genuinely leaves the building.
Yes – low-noise units are one of the most common upgrade requests. If your current fan is audible from the bedroom, a modern quiet unit is a genuine quality-of-life improvement for a like-for-like price.
It switches itself on when the air gets moist and off when the room is dry – no one has to remember anything. For kids’ bathrooms, rentals and anyone who showers before dawn, it is the single best upgrade per dollar in this category.
Yes – including ducting recirculating hoods to the outside, which transforms how well they clear smoke and smells. Details on our kitchen rangehood page.
We take the old unit away, and the new one is fitted to cover the existing opening wherever the sizes allow. Where a ceiling patch is genuinely needed we tell you at quote time, not once the old fan is already out.
Yes – multi-bathroom and multi-unit installations are a specialty, with scheduling around tenants and documentation for strata and owners corporations. See our commercial and strata page.
A like-for-like swap: usually one to two hours. A new location with wiring and ducting: typically half a day. Either way you get a time estimate with the quote and photos of the finished work.
All major brands sold in Australia. We spec the fan to the room’s extraction needs first, then offer options at different price points within that spec – never the reverse.
Talk to us before plaster goes up: running ducting and wiring is dramatically cheaper with the ceiling open. We happily coordinate timing with your builder.
The fan carries its manufacturer warranty and FreshDuct backs the workmanship – if something we installed is not right, we come back and make it right. You also pay only after the job is done.
FreshDuct installs and replaces exhaust fans in every room that makes steam or smells: bathrooms and ensuites, toilets, laundries, walk-in robes off ensuites, and kitchens via ducted rangehoods. Each room gets a fan sized to its volume and a discharge path that ends outside the building – the two details that separate a working installation from a decorative one. Suburbs we cover include Fremantle, Joondalup, Subiaco, Cottesloe, Scarborough, Morley, Armadale, Rockingham, Mandurah, Canning Vale, Applecross, Claremont, Hillarys, Ellenbrook and everywhere between.
Many Perth homes have fans that were undersized on day one or vented into the roof by the original builder. When we replace a fan we correct the whole picture – capacity, ducting and discharge – so you are not paying twice for the same shortcut.
The best fan in Perth does nothing switched off. Run-on timers keep extracting after you leave the room; humidity sensors automate the whole decision. Both are modest additions during an installation, and both pay for themselves the first winter you stop wiping down a ceiling.
Renovating a bathroom, preparing a rental for lease, or fixing items from a building inspection – we install to current ventilation requirements and document the work with photos, so your builder, agent or conveyancer has what they need on file.
Same-day slots most days, 7 days a week, right across metropolitan Perth — and if your suburb is not listed, it is almost certainly still covered. Just ask.
A properly installed fan costs from $250 and solves the steam, the mould and the musty towels for the next decade. Firm quote today, installed this week.
